| Detection condition |
- Parking position sensor is locked.
Precondition
- Selector lever is in D or R position.
- Vehicle cannot accelerate from standstill by depressing the accelerator pedal.
|
| Fail-safe |
- Inhibits i-stop control. (Without Mazda M Hybrid boost)
- Inhibits AAS.
|
| Possible cause |
- ATF is less than Specified value. (Refer to [AUTOMATIC TRANSMISSION FLUID (ATF) INSPECTION
] in service information).
- Control valve body malfunction (ON/OFF solenoid valve No. 2 malfunction) (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
WARNING:
- When starting with increased engine speed, do so in a safe place to prevent accidents due to sudden jumping out.
NOTE:
- If the vehicle cannot start, increase the engine speed to the extent that it does not overrev and try to start several times.
- Drive the vehicle. (selector lever at D or R position)
|
| System wiring diagram |
|