| Detection condition |
- When the accelerator pedal is depressed, the engine or the motor revs and the vehicle cannot accelerate from a standstill.
|
| Fail-safe |
- Inhibits malfunctioning gear.
- Limits engine torque.
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits switching from engine-only driving to EV driving. (With Mazda M Hybrid boost)
- Inhibits i-stop control. (Without Mazda M Hybrid boost)
- Inhibits AAS.
|
| Possible cause |
- Control valve body malfunction (ON/OFF solenoid valve No. 1 malfunction) (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
WARNING:
- When starting with increased engine speed, do so in a safe place to prevent accidents due to sudden jumping out.
NOTE:
- If the vehicle cannot start, increase the engine speed to the extent that it does not overrev and try to start several times.
- Drive the vehicle under the following condition:
- Vehicle speed: 30 km/h {19 mph} or more
|
| System wiring diagram |
|