| Detection condition |
- The TCM detects a TFT sensor circuit malfunction.
Precondition
- Battery voltage is the standard or more.
|
| Fail-safe |
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits switching from engine-only driving to EV driving. (With Mazda M Hybrid boost)
- Inhibits i-stop control. (Without Mazda M Hybrid boost)
- Inhibits AAS.
|
| Possible cause |
- Malfunction in the following control valve body component parts (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
- TFT sensor circuit (including connector/terminal) (short to ground)
- TCM
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Switch the ignition ON (engine off or on).
|
| System wiring diagram |
|