Details On DTCs

WARNING: This page is about a different variant/trim than selected.

U2300: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Global central configuration error
Detection condition	Determination conditions	Any one of the following conditions is met: No configuration of the body control module (BCM). The configuration signal with the estimated CAN ID is not sent from the body control module (BCM). The configuration signal value sent via CAN from the body control module (BCM) is unknown or invalid. The configuration signal value sent via CAN from the body control module (BCM) is a value other than the estimated value. The configuration signal value sent via CAN from the body control module (BCM) does not match the PCM value.
	Preconditions	Battery voltage: 9.45 V or more 1 Switch the ignition ON (engine off or on) 1: Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	10 s period
	Drive cycle	1
	Self test type	CMDTC self test, KOER self test
	Sensor used	PCM
Fail-safe	Operates by the previously learned configuration value. Inhibits engine-stop by i-stop control.
Vehicle status when DTCs are output	Not applicable
Possible cause	CAN drive error (body control module (BCM) or PCM) Configuration data for the body control module (BCM) is incorrectly set Malfunction in wiring harness (including connector/terminal) between body control module (BCM) and PCM Body control module (BCM) incorrect installation Body control module (BCM) malfunction Error in non-volatile memory in PCM PCM malfunction