DTC U213D-00: Can Communication System: Communication Error To TCM (PYUL)
WARNING: This page is about a different variant/trim than selected.
U213D: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
CAN communication system: Communication error to TCM |
| Detection condition |
- Communication error between the PCM and TCM continues for a specified period of time.
|
| Fail-safe |
- Controls the turbine rotation signal at 0.
- Inhibits the AT torque reduction request.
- Inhibits engine-stop by i-stop control.
|
| Possible cause |
- DTCs are stored in the following modules.
- TCM malfunction (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
]
).
- PCM malfunction (Refer to [PCM REMOVAL/INSTALLATION
]
).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
- Switch the ignition ON (engine on).
|
| System Wiring Diagram |
|