Details On DTCs

WARNING: This page is about a different variant/trim than selected.

U1032: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Vehicle control module (VCM) error
Detection condition	Determination conditions	Any one of the following conditions is met: CAN bus communication line malfunction between vehicle control module (VCM) and PCM Vehicle control module (VCM) internal malfunction (built-into body control module (BCM))
	Preconditions	The following conditions continue for 1.5 s: Battery voltage: 9.45 V or more 1 Switch the ignition ON (engine off or on) 1: Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	2 s period
	Drive cycle	1
	Self test type	CMDTC self test, KOEO self test, KOER self test
	Sensor used	PCM
Fail-safe	Inhibits engine-stop by i-stop control.
Vehicle status when DTCs are output	Not applicable
Possible cause	CAN drive error (vehicle control module (VCM) or PCM) Malfunction in wiring harness (including connector/terminal) between body control module (BCM) and PCM Vehicle control module (VCM) malfunction (built-into body control module (BCM)) PCM malfunction