DTC U0336-00: SAS Control Module Error (PYUL)
WARNING: This page is about a different variant/trim than selected.
U0336: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
SAS control module error |
| Detection condition |
- The PCM detects a communication error (check sum error/rolling counter error) to SAS control module.
|
| Fail-safe |
- Inhibits engine-stop by i-stop control.
|
| Possible cause |
- DTCs are stored in the following modules.
WARNING:
- Handling the component parts of the SRS air bag system improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings and cautions before handling the component parts of the SAS air bag system. (Refer to [AIR BAG SYSTEM SERVICE WARNINGS
]
). (Refer to [AIR BAG SYSTEM SERVICE CAUTIONS
]
).
- SAS control module connector or terminal malfunction (See CONNECTOR INSPECTION
.)
- Body control module (BCM) connector or terminal malfunction (See CONNECTOR INSPECTION
.)
- PCM connector or terminal malfunction (See CONNECTOR INSPECTION
.)
- SAS control module malfunction (Refer to [SAS CONTROL MODULE REMOVAL/INSTALLATION
]
).
- Body control module (BCM) malfunction (Refer to [BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION
]
).
- PCM malfunction (Refer to [PCM REMOVAL/INSTALLATION
]
).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
| System Wiring Diagram |
|