DTC U0298-00: Lin Communication System: Communication Error Between Dc-Dc Converter And Pcm (PYUL)
WARNING: This page is about a different variant/trim than selected.
U0298: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
LIN communication system: Communication error between DC-DC converter and PCM |
| Detection condition |
- The PCM detects a communication error between DC-DC converter and PCM.
|
| Fail-safe |
- Inhibits engine-stop by i-stop control.
|
| Possible cause |
- DTCs are stored in the PCM. (other than U0298: 00) (See DTC TABLE [PCM (PYUL)]
.)
- Malfunction in wiring harness (including connector/terminal) between battery and DC-DC converter (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between IG1 relay and DC-DC converter (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between DC-DC converter and PCM (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- DC-DC converter malfunction (Refer to [DC-DC CONVERTER INSPECTION
]
).
- PCM malfunction (Refer to [PCM REMOVAL/INSTALLATION
]
).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
Courtesy of MAZDA MOTORS CORP.
|
| 1 |
Battery |
| 2 |
IG1 relay |
| 3 |
DC-DC converter |
| 4 |
PCM |