DTC P2610-00: Body Control Module (BCM) Internal Malfunction (PYUL)
WARNING: This page is about a different variant/trim than selected.
P2610: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Body control module (BCM) internal malfunction |
| Detection condition |
Determination condition
- When any of the following conditions is met.
- When the engine is stopped, the amount of time the engine has been stopped does not match between the 2 processors in the instrument cluster for a specified time or more.
- The instrument cluster cannot receive the engine speed signal from the PCM for a specified time or more.
- The instrument cluster cannot count the amount of time the engine has been stopped for a specified time or more.
Precondition
- Ignition is switched ON (engine on)
- The following DTCs are not detected
|
| Fail-safe |
- The fast idle up correction for drive-by-wire control is inhibited.
- Inhibits engine-stop by i-stop control.
|
| Vehicle status when DTCs are output |
|
| Repeatability verification procedure |
NOTE:
- DTC P2610: 00 can be cleared by performing the engine start and stop procedure.
- Start the engine.
- Stop the engine.
- Switch the ignition off and wait for 5 min or more.
- Switch the ignition ON (engine off).
|
| Inspection/action procedure |
NOTE:
Because DTC P2610:00 may have been stored in the PCM when the PCM received the [ECU Reset]command from the diagnostic tester, implement the repeatability verification procedure first. If DTCP2610:00 does not recur after the repeatability verification procedure, the vehicle is normal.
- Proceed with the inspection/action in the order from Step 1 below.
- After part repair or replacement, perform the repeatability verifi cation procedure and perform a DTCinspection. (See DTC INSPECTION
)
- If the DTC inspection indicates the same DTC again, go to the next step.
- Inspect the wiring harness (including connector/terminal) between the battery and body control module (BCM).
Purpose/reason (possible cause)
Malfunction in wiring harness (including connector/terminal) between battery and body control module (BCM)
Referred to workshop manual item
(See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Replace the body control module (BCM).
Purpose/reason (possible cause)
Body control module (BCM) malfunction (applicable part can not be inspected to determine integrity)
Referred to workshop manual item
(See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION
.)
- Replace the PCM.
Purpose/reason (possible cause)
PCM malfunction (no other possible malfunction considered)
Referred to workshop manual item
(See PCM REMOVAL/INSTALLATION
)
|
Refer to SYSTEM WIRING DIAGRAMS
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
Battery |
| 2 |
BCM |
| Function explanation (DTC detection outline) |
|