Verify Quick Release Connector (Fuel System) Positions
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Always keep sparks and flames away from fuel. Fuel can easily ignite which could cause serious injury or death, and damage to equipment.
- Highly pressurized fuel may spray out if the fuel line is cut. Due to the following dangers occurring with a fuel spray, always complete the [Fuel Line Safety Procedure] to prevent the fuel from spraying.
- Fuel may cause irritation if it comes in contact with skin and eyes.
- If fuel ignites and causes a fire, it may lead to serious injury or death, and damage to property and facilities.
- A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before servicing the fuel system, make sure to discharge static electricity by touching a vehicle.
CAUTION:
- If there is foreign matter on the connecting area of the quick release connector it might damage the connector or the opposite side. To prevent this, disconnect the quick release connector and clean the connecting area before connecting it again.
- Verify the type and position and install/remove correctly.
COMPONENT OPERATIONS
| Component No. | Refer to |
|---|---|
| 1 | Quick release connector (fuel system) No. 1 |
| 2 | Quick release connector (fuel system) No. 2 |
| 3 | Quick release connector (fuel system) No. 3 |
| 4 | Quick release connector (fuel system) No. 4 |
| 5 | Quick release connector (fuel system) No. 5 |
| 6 | Quick release connector (fuel system) No. 6 |
| 7 | Quick release connector (fuel system) No. 7 |