Remove Passenger Side Strut Tower Bar: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
- the figure below shows the right side (same as left side).
Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONSStep Part name Applicable condition 1 Connector With windshield wiper de-icer - 2 Wiring harness clip
(See Wiring harness clip removal note ).- - 3 Bolt - 35 N.m {3.55 kgf.m, 25.8 ft.lb} 4 Nut - 35 N.m {3.55 kgf.m, 25.8 ft.lb} 5 Strut tower bar - -