LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel System (VIN A)) >> Fuel-Filler Pipe Removal/Installation [PYUL] >> Remove Rear Over Fender (LH) >> Rear over fender removal note

Rear over fender removal note

WARNING: This page is about a different variant/trim than selected.
  1. Apply protective tape to the location shown in the figure below to prevent scratches or damage.
    • the figure below shows the left side (same as right side).
      G16702464Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    Protective tape attachment positions
  2. Pull the rear over fender in the direction of the arrow shown in the figure below and detach the clips form the rear bumper.
    • the figure below shows the left side (same as right side).
      G16702465Courtesy of MAZDA MOTORS CORP.
  3. Using a tape-wrapped fastener remover, move it in the direction of the arrow shown in the figure below and detach the clips from the body.
    • the figure below shows the left side (same as right side).
      G16702466Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    300 mm {11.8 in} or more
    (1) (2)... Servicing procedure
  4. Remove the rear over fender.
scientia non olet · About LEMON Manuals