Remove Rear Under Cover No. 1 (Left Side)
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
Courtesy of MAZDA MOTORS CORP. TIGHTENING TORQUE SPECIFICATIONS
| Step |
Part name |
 |
| 1 |
Nut |
9.5 N.m {95 kgf.cm, 82 in.lbf} |
| 2 |
Fastener |
- |
| 3 |
Bolt |
11 N.m {110 kgf.cm, 95 in.lbf} |
| 4 |
Cap nut |
- |
| 5 |
Rear under cover No. 1 |
- |