Remove Intake Manifold

WARNING: This page is about a different variant/trim than selected.

Remove in the order indicated in the table.

Fig 1: Intake Manifold Components Location With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATIONS

Step	Part name
1	Bolt	-	9.5 N.m {97 kgf.cm, 84 in.lbf}
2	Bolt	-	9.5 N.m {97 kgf.cm, 84 in.lbf}
3	Connector	-	-
4	Bolt	-	52 N.m {5.3 kgf.m, 38.3 ft.lb}
5	A/C compressor component	-	-
6	Wiring harness clip	-	-
7	Air-bleed plug	-	-
8	Connector	-	-
9	Bolt	-	9.5 N.m {97 kgf.cm, 84 in.lbf}
10	Purge solenoid valve component	-	-
11	Bolt	-	9.5 N.m {95 kgf.cm, 82 in.lbf}
12	Bolt	-	9.5 N.m {97 kgf.cm, 84 in.lbf}
13	Connector	-	-
14	Wiring harness clip	-	-
15	Hose clip	-	-
16	Connector	-	-
17	Bolt	-	18 N.m {1.85 kgf.m, 13.3 ft.lb}
18	Intake manifold component	-	-
19	Gasket	Replacement part	-