Resistance inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative lead-acid battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Disconnect the fuel injector connector. (See FUEL INJECTOR REMOVAL/INSTALLATION [PYUL] ).
- Inspect the resistance between fuel injector terminals A and B.
1.23-2.03 Ω [Surrounding ambient temperature: 0-80°C {32-176°F}]
- If not within the standard, replace the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [PYUL] ).