Remove Service Hole Cover: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
Courtesy of MAZDA MOTORS CORP. TIGHTENING TORQUE SPECIFICATIONS
| Procedure |
Part name |
Applicable condition |
 |
| 1 |
Screw |
Continuous |
2.5 N.m {25 kgf.cm, 22 in.lbf} |
| 2 |
Service hole cover |
Continuous |
- |
| 3 |
Grommet |
Continuous |
- |