Perform Panorama Sunroof System Initialization

WARNING: This page is about a different variant/trim than selected.

NOTE:

If removal/installation of the following parts or manual open/close operation of the sunroof front glass panel is performed, the panorama sunroof system will not operate normally. Therefore, perform the initialization.
- Panoramic sunroof unit
- Sunroof front glass panel motor
- Sunshade motor
- Sunroof front glass panel
- Sunroof rear glass panel
- Sunshade

Push the panorama sunroof switch toward the front to fully close the sunroof front glass panel and the sunshade.
- If the panorama sunroof is operated, but reverses and stops mid-operation (anti-pinch function operates), perform the following procedure 5 times to fully close the sunroof front glass panel and the sunshade.
  - Push the panorama sunroof switch toward the front to reverse and stop the sunroof front glass panel (antipinch function operation).
NOTE:
- The initialization mode starts and the auto function is canceled by operating the anti-pinch function 5 times.
Release the panorama sunroof switch.
Push and hold the panorama sunroof switch toward the front for 13 s or more.
NOTE:
- Perform Step 5 within 6 s after performing Step 4.
Release the panorama sunroof switch.
Push and hold the panorama sunroof switch toward the front until the following procedure (1) to (3) are completed.
1. Move the sunshade from the fully closed position to the fully open position.
2. Move the sunroof front glass panel from the fully open position to the fully closed position after moving it from the fully closed position to the fully open position.
3. Move the sunshade from the fully open position to the fully closed position.
Release the panorama sunroof switch to complete initialization.
Operate the panorama sunroof switch and verify that the sunroof front glass panel and the sunshade operate automatically.
- If the sunroof front glass panel and the sunshade do not operate automatically, repeat the procedure from Step 1.