Remove Intake Camshaft: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
TIGHTENING TORQUE SPECIFICATIONS
| Procedure | Part name | |||
|---|---|---|---|---|
| 1 | Bolt (See INTAKE CAMSHAFT REMOVAL NOTE ) |
- | - | 9.5 N.m {97 kgf.m, 84 ft.lb} |
| 2 | Rear housing component (See REAR HOUSING COMPONENT INSTALLATION NOTE ) |
- | - | - |
| 3 | Gasket (See REAR HOUSING COMPONENT INSTALLATION NOTE ) |
- | Replacement part | - |
| 4 | Bolt | - | - | 9.5 N.m {97 kgf.m, 84 ft.lb} |
| 5 | Intake camshaft cap | - | - | - |
| 6 | Intake camshaft (See INTAKE CAMSHAFT REMOVAL NOTE ) |
Gear oil (SAE 90 or equivalent) or engine oil | - | - |
| 8 | Exhaust camshaft cap | - | - | - |
| 9 | Exhaust camshaft component (See EXHAUST CAMSHAFT REMOVAL NOTE ) |
Gear oil (SAE 90 or equivalent) or engine oil | - | - |