Remove Generator
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
Courtesy of MAZDA MOTORS CORP. TIGHTENING TORQUE SPECIFICATIONS
| Procedure |
Part name |
 |
| 1 |
Nut |
12.5 N.m {125 kgf.cm, 108 in.lb} |
| 2 |
Terminal B cable |
- |
| 3 |
Connector |
- |
| 4 |
Bolt |
44.5 N.m {4.55 kgf.m, 32.95 ft.lb} |
| 5 |
Generator |
- |