Remove Automatic Transmission: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
- The electric motor temperature sensor is built into the automatic transmission.
- Remove using the procedure shown in the figure below.
TIGHTENING TORQUE SPECIFICATIONS
| Step | Part name | |
|---|---|---|
| 1 | Wiring harness clip | - |
| 2 | Connector | - |
| 3 | Bolt | 9.5 N.m {95 kgf.cm, 82 in.lb} |
| 4 | Harness cable (See Precautions when disconnecting the harness cable ) |
- |
| 5 | Breather hose (See Breather hose connection note ) |
- |
| 6 | Water hose (See Water Hose Installation Note ) |
- |
| 7 | Bolt | 44.5 N.m {4.55 kgf.m, 32.95 ft.lb} |
| 8 | Automatic transmission clutch component | - |