Inspect Throttle Position Sensor: Notes
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- This inspection method cannot be correctly performed if there is a malfunction with the accelerator pedal position sensor and the throttle valve actuator. Before performing this inspection, verify that no DTCs have been detected for the accelerator pedal position sensor and the throttle valve actuator.
NOTE:
- The throttle position sensor cannot be removed as a single unit. If the throttle position sensor is replaced, replace it with the throttle body as a single unit.
- Perform the procedure with the M-MDS connected to the DLC-2.