Function inspection
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Perform the procedure with the main power switched ON (READY off).
- Display the PIDs [TP1] and [TP2]. (Refer to [PID/DATA MONITOR INSPECTION ] in the appropriate troubleshooting information )
- Compare the voltage and opening angle indications for PIDs [TP1] and [TP2] with the standard in the table indicated below.
- If they match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION )
Standard
STANDARD TP1 SPECIFICATIONS
| Condition | TP1 | TP2 | ||
|---|---|---|---|---|
| V | % | V | % | |
| Accelerator pedal released | Approx. 1.11 | Approx. 22 | Approx. 3.92 | Approx. 22 |
| Accelerator pedal depressed | Approx. 4.59 | Approx. 92 | Approx. 0.41 | Approx. 92 |