DTC inspection
WARNING: This page is about a different variant/trim than selected.
- Using the M-MDS, perform a DTC inspection and verify if any PCM-related DTCs are detected. (Refer to [DTC INSPECTION
] in the appropriate troubleshooting information
)
DTC is detected
- Replace the PCM if the detected DTC is P0601:00, P0604:00, P0606:00, P0607:00, P0610:00, or P06B8:00. (See ECM REMOVAL/INSTALLATION [PYUL] ).
- If the detected DTC is other than P0601:00, P0604:00, P0606:00, P0607: 00, P0610:00, or P06B8:00, inspect the possible cause of the detected DTC in the order from the top. (Refer to [DTC TABLE [PCM]
] in the appropriate troubleshooting information
)
- If the malfunction has not been resolved, replace the PCM. (See ECM REMOVAL/INSTALLATION [PYUL] )
No DTC is detected
- Perform a visual inspection. (See VISUAL INSPECTION )