DTC inspection
WARNING: This page is about a different variant/trim than selected.
- Using the M-MDS, perform a DTC inspection and verify if any MAP sensor-related DTCs are detected. (Refer to [DTC INSPECTION
] in the appropriate troubleshooting information
)
DTC is detected
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [ECM]
] in the appropriate troubleshooting information
)
- If the malfunction is not resolved, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR No. 2 REMOVAL/INSTALLATION [PYUL] ).
No DTC is detected
- Perform a visual inspection. (See VISUAL INSPECTION )
- Inspect for possible causes of detected DTCs in the order from the top. (Refer to [DTC TABLE [ECM]
] in the appropriate troubleshooting information
)