LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (VIN A) (2 Of 2)) >> MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR No. 2 REMOVAL/INSTALLATION [PYUL] >> Remove Windshield Wiper Motor And Link >> Notes

Remove Windshield Wiper Motor And Link: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Always apply protective tape to the windshield edge. If the windshield wiper motor and link contacts the windshield, it could damage the windshield.
G16699175Courtesy of MAZDA MOTORS CORP.
SYMBOL AND CONTENT DESCRIPTION

Symbol Content
Protective tape attachment positions
  1. Remove using the procedure shown in the figure.
Fig 1: Windshield Wiper Motor And Link Bolt With Torque Specifications
G16707690Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Step Part name
1 Connector -
2 Bolt
(See Bolt installation note ).
8.0 N.m {82 kgf.cm, 71 in.lbf}
3 Windshield wiper motor and link -