Driver's side windshield wiper arm and blade installation note

WARNING: This page is about a different variant/trim than selected.

Use a wire brush to clean the serrated connecting part.

Courtesy of MAZDA MOTORS CORP.

SYMBOL AND CONTENT DESCRIPTION

Symbol	Content
1	Serration engagement area

If the serrated connecting part is damaged, replace the windshield wiper motor and link.

Align the driver's side windshield wiper blade end with the hollowed mark in the ceramic coating and install.

If the hollowed mark in the ceramic coating cannot be located, adjust the driver's side windshield wiper blade end to the range shown in the figure and install.

Courtesy of MAZDA MOTORS CORP.

SYMBOL AND CONTENT DESCRIPTION

Symbol	Content
	8-12 mm {0.32-0.47 in}
1	Ceramic hollow mark
2	Driver's side windshield wiper blade
3	Cowl grille

Install the nut.
Switch the ignition ON (engine off or on).
Operate the windshield wipers at low speed.
Turn the windshield wiper switch OFF.
Verify that the driver's side windshield wiper is stopped at the park position by the auto-stop function.
- If the driver's side windshield wiper is not installed to the park position, change the driver's side windshield wiper arm and serrated connecting part one groove at a time and adjust it to the park position.