LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (VIN A) (2 Of 2)) >> MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR No. 2 REMOVAL/INSTALLATION [PYUL] >> Remove Driver's Side Front Fender Molding >> Notes

Remove Driver's Side Front Fender Molding: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure.
    • The figure shows the left side (same as right side).
G16707680Courtesy of MAZDA MOTORS CORP.
PART NAME DESCRIPTION

Step Part name
1 Front fender molding
(See Front fender molding removal note ).
scientia non olet · About LEMON Manuals