LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (VIN A) (2 Of 2)) >> Fuel Vapor Temperature Sensor Removal/Installation [PYUL] >> Remove Set Plate >> Set plate removal note

Set plate removal note

WARNING: This page is about a different variant/trim than selected.
  1. Install the SST as shown in the figure.
    G16702275Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    49 UN31 0123
  2. Remove the set plate using the SST.
scientia non olet · About LEMON Manuals