Remove Rear Propeller Shaft: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure.
Step 1
TIGHTENING TORQUE SPECIFICATIONS
| Procedure | Part name | ||
|---|---|---|---|
| 1 | Connector | - | - |
| 2 | Bolt | - | 9.5 N.m {95 kgf.cm, 82 in.lbf} |
| 3 | O-ring | Replacement part | - |
| 4 | Bolt | - | 9.5 N.m {95 kgf.cm, 82 in.lbf} |
| 5 | Nut | - | 9.5 N.m {95 kgf.cm, 82 in.lbf} |
| 6 | Bolt | - | 9.5 N.m {95 kgf.cm, 82 in.lbf} |
| 7 | O-ring | Replacement part | - |
| 8 | High voltage battery coolant cooling piping component | - | - |
Step 2
TIGHTENING TORQUE SPECIFICATIONS
| Procedure | Part name | ||
|---|---|---|---|
| 9 | Heater hose (See Heater hose connection note HEATER HOSE CONNECTION NOTE ) |
- | - |
| 10 | Heater hose (See Heater hose installation note ) |
- | - |
| 11 | Heater hose (See Heater hose connection note ) |
- | - |
| 12 | Heater hose (See Heater hose connection note ) |
- | - |
| 13 | Bolt | - | 11 N.m {110 kgf.cm, 95 in.lbf} |
| 14 | Heater pipe component (See HEATER PIPE COMPONENT INSTALLATION NOTE ) |
- | - |
| 15 | Bolt | - | 80 N.m {8.15 kgf.m, 59 ft.lbf} |
| 16 | Nut | - | - |
| 17 | Bolt | - | 44.5 N.m {4.55 kgf.m, 32.95 ft.lbf} |
| 18 | Rear propeller shaft (See Rear propeller shaft removal note (reused) ). (See Rear propeller shaft installation note (reused) ). (See Rear propeller shaft installation note (newly replaced) ). |
- | - |