LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (VIN A) (2 Of 2)) >> Fuel Vapor Temperature Sensor Removal/Installation [PYUL] >> Remove Joint Hose >> Joint hose and hose clamp installation note

Joint hose and hose clamp installation note

WARNING: This page is about a different variant/trim than selected.
  1. Align the joint hose markings with the pipe markings as shown in the figure and assemble.
    G16707569Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    1 Pipe marking
    2 Joint hose marking
    3 Hose clamp assembly range
    3 mm {0.1 in}
    90°
    45°
  2. Align the joint hose marking with the fuel-filler pipe marking as shown in the figure and assemble.
G16707570Courtesy of MAZDA MOTORS CORP.
SYMBOL AND CONTENT DESCRIPTION

Symbol Content
1 Marking of fuel-filler pipe
2 Joint hose marking
3 Hose clamp assembly range
3 mm {0.1 in}
90°
45°
scientia non olet · About LEMON Manuals