LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System (VIN A) (2 Of 2)) >> Fuel Vapor Temperature Sensor Removal/Installation [PYUL] >> Remove Front Under Cover No. 3

Remove Front Under Cover No. 3

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure.
Fig 1: Front Under Cover No. 3 Bolt With Torque Specifications
G16707500Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Step Part name
1 Bolt 11 N.m {110 kgf.cm, 95 in.lbf}
2 Fastener -
3 Front undercover No. 3 -
scientia non olet · About LEMON Manuals