LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Fuel Tank Pressure Sensor Removal/Installation [PYUL] >> Remove Rear Over Fender (LH) >> Notes

Remove Rear Over Fender (LH): Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure below.
    • the figure below shows the left side (same as right side).
    G16702463Courtesy of MAZDA MOTORS CORP.
    PART NAME DESCRIPTION

    Step Part name
    1 Fastener
    2 Rear over fender
    (See Rear over fender removal note ).
    (See Rear over fender installation note ).
  2. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals