LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Fuel Tank Pressure Sensor Removal/Installation [PYUL] >> Remove Insulator (Rear) >> Notes

Remove Insulator (Rear): Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove in the order indicated in the table.
Fig 1: Insulator (Rear) Nut With Torque Specifications
G16707423Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Step Part name
1 Nut 9.5 N.m {95 kgf.cm, 82 in.lb}
2 Insulator (rear)
(See INSULATOR (REAR) INSTALLATION NOTE )		 -
scientia non olet · About LEMON Manuals