LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Fuel Tank Pressure Sensor Removal/Installation [PYUL] >> Remove Fuel Tank Pressure Sensor >> Nut and bolt installation note

Nut and bolt installation note

WARNING: This page is about a different variant/trim than selected.
  1. Install the nuts and the bolts as shown in the figure below.
Fig 1: Fuel Tank Pressure Sensor Nuts And Bolts Tightening Sequence
G16707445Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Symbol Content
(1) (2)... Servicing procedure
Temporarily tighten
11 N.m {110 kgf.cm, 95 in.lb}
scientia non olet · About LEMON Manuals