LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove the front bumper component >> Fastener D Removal Note

Fastener D Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Partially peel back the front over fender upper until fasteners D and bolts B can be removed as shown in the figure below.
    • Figure also shows the left side (same for the right side).
    G16707244Courtesy of MAZDA MOTORS CORP.
  2. Remove fasteners D.
scientia non olet · About LEMON Manuals