LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Rear Propeller Shaft >> Rear propeller shaft removal note (reused)

Rear propeller shaft removal note (reused)

WARNING: This page is about a different variant/trim than selected.
  1. Before removing the rear propeller shaft, place an alignment mark on the boot and shaft parts as shown in the figure below.
G16699270Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals