LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Rear Propeller Shaft >> Rear propeller shaft installation note (newly replaced)

Rear propeller shaft installation note (newly replaced)

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • A new rear propeller shaft is delivered with a protector equipped.
  1. Install the rear propeller shaft to the vehicle with the protector attached.
    G16699274Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    1 Protector
  2. Temporarily tighten the front and rear bolts and nuts.
  3. Temporarily tighten the center bearing support bolts.
    CAUTION:
    • If the center bearing support bracket is installed upside down, an abnormal noise may occur. Install the bracket as shown in the figure below.
    G16707292Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    1 Vehicle lower side
    2 Bracket
  4. Remove the protector from the rear propeller shaft.
  5. Shake the position at the arrow shown in the figure below up and down 2 or 3 times so that the center bearing support bolts and rubber bushings are adjusted correctly according to the good example.
    G16707293Courtesy of MAZDA MOTORS CORP.
  6. Tighten in the order of the front side, rear side, and then the center bearing support.
scientia non olet · About LEMON Manuals