LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Passenger Side Front Over Fender Upper >> Front over fender upper removal note

Front over fender upper removal note

WARNING: This page is about a different variant/trim than selected.
  1. Apply protective tape to the location shown in the figure below to prevent scratches or damage.
    • the figure below shows the left side (same as right side).
    G16699200Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    Protective tape attachment positions
  2. Pull the front over fender upper in the direction of the arrow shown in the figure below and detach the clips from the front bumper.
    • the figure below shows the left side (same as right side).
    G16707228Courtesy of MAZDA MOTORS CORP.
  3. Using a tape-wrapped fastener remover, move it in the direction of the arrow shown in the figure below and detach the clips from the body.
    • the figure below shows the left side (same as right side).
    G16707229Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    300 mm {1.18 in} or more
    (1) (2)... Servicing procedure
  4. Remove the front over fender upper.
scientia non olet · About LEMON Manuals