LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Passenger Side Front Over Fender Lower >> Front over fender lower removal note

Front over fender lower removal note

WARNING: This page is about a different variant/trim than selected.
  1. Press the front over fender lower in the direction of the arrow (1) shown in the figure below to create a gap of approx. 3 mm {1 in} between the front over fender lower and the front fender.
    • the figure below shows the left side (same as right side).
    G16707222Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    Approx. 3 mm {0.1 in}
  2. Apply protective tape to the location shown in the figure below to prevent scratches or damage.
    • the figure below shows the left side (same as right side).
    G16707223Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    Protective tape attachment positions
  3. Insert a remover tool into the position shown in the figure below, move it in the direction of the arrow, and then detach the clip from the body.
    • the figure below shows the left side (same as right side).
    G16707224Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    50 mm {2.0 in}
    25 mm {0.98 in}
  4. Detach the clips from the body using a remover tool.
    • the figure below shows the left side (same as right side).
    G16707225Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    (1) (2)... Servicing procedure
  5. Remove the front over fender lower.
scientia non olet · About LEMON Manuals