LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Intake Air Guide (Upper) >> Intake air guide (upper) removal note

Intake air guide (upper) removal note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake air guide (upper) as shown in the figure below.
    G16707252Courtesy of MAZDA MOTORS CORP.
  2. Verify that the intake air guide (upper) is inserted into the seal plate and engaged.
    • the figure below shows the left side (same as right side).
G16699236Courtesy of MAZDA MOTORS CORP.