LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Driver's Side Front Fender Molding >> Front fender molding removal note

Front fender molding removal note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front fender molding as shown in the figure below.
    • the figure below shows the left side (same as right side).
G16707184Courtesy of MAZDA MOTORS CORP.
SYMBOL AND CONTENT DESCRIPTION

Symbol Content
(1) (2)... Servicing procedure
scientia non olet · About LEMON Manuals