LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Driver Side Front Splash Shield No. 2 >> Notes

Remove Driver Side Front Splash Shield No. 2: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure below.
    • the figure below shows the left side (same as right side).
G16707236Courtesy of MAZDA MOTORS CORP.
PART NAME DESCRIPTION

Step Part name
1 Fasteners
2 Front splash shield No. 2
(See Front splash shield No. 2 removal note )
scientia non olet · About LEMON Manuals