LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Oil Temperature Sensor/Engine Oil Pressure Sensor Removal/Installation [PYUL] >> Remove Driver Side Front Splash Shield No. 1

Remove Driver Side Front Splash Shield No. 1

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure below.
    • the figure below shows the left side (same as right side).
Fig 1: Driver Side Front Splash Shield No. 1 Fastener And Screw With Torque Specifications
G16707235Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Step Part name
1 Fastener -
2 Screw 2 N.m {20 kgf.cm, 17 in.lb}
3 Front splash shield No. 1 -
scientia non olet · About LEMON Manuals