LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Engine Coolant Temperature (ECT) Sensor Removal/Installation [002] >> Remove Passenger Side Front Deflector >> Fastener removal note

Fastener removal note

WARNING: This page is about a different variant/trim than selected.
  1. Partially peel back the front over fender upper until the fasteners can be removed as shown in the figure below.
    • the figure below shows the left side (same as right side).
    G16707116Courtesy of MAZDA MOTORS CORP.
  2. Remove the fasteners.
scientia non olet · About LEMON Manuals