LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Crankshaft Position (CKP) Sensor Removal/Installation [002] >> Remove Front Under Cover No. 2

Remove Front Under Cover No. 2

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure below.
Fig 1: Front Under Cover No. 2 Bolt With Torque Specifications
G16707061Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Step Part name
1 Bolt 11 N.m {110 kgf.cm, 95 in.lb}
2 Fastener -
3 Front under cover No. 2 -
scientia non olet · About LEMON Manuals