Remove Crankshaft Position Sensor
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- When replacing the crankshaft position sensor, verify that there is no foreign matter on it such as metal shavings. If it is assembled with foreign matter on it, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
- If the crankshaft position sensor is newly replaced, perform the crankshaft position sensor learning value clearing procedure to clear the learning value stored in the PCM. Otherwise, engine performance may not be fully achieved.
- Remove in the order indicated in the table.
TIGHTENING TORQUE SPECIFICATIONS
| Step | Part name | |
|---|---|---|
| 1 | Connector | - |
| 2 | Bolt | 9 N.m {92 kgf.cm, 80 in.lb} |
| 3 | Crankshaft position sensor | - |