LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (VIN A) (1 Of 2)) >> Camshaft Position (CMP) Sensor Removal/Installation [002] >> Remove Intake Camshaft Position Sensor

Remove Intake Camshaft Position Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Remove in the order indicated in the table.
Fig 1: Intake Camshaft Position Sensor Bolt With Torque Specifications
G16707044Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONS

Step Part name
1 Connector - -
2 Bolt - 9 N.m {92 kgf.cm, 80 in.lb}
3 Intake Camshaft Position Sensor - -
4 O-ring Replacement part -
scientia non olet · About LEMON Manuals