Remove Driver Side Strut Tower Bar: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
- the figure below shows the left side (same as right side).
TIGHTENING TORQUE SPECIFICATIONS
| Step | Part name | |
|---|---|---|
| 1 | Wiring harness clip (See Wiring harness clip removal note ). |
- |
| 2 | Bolt | 35 N.m {3.55 kgf.m, 25.8 ft.lb} |
| 3 | Nut | 35 N.m {3.55 kgf.m, 25.8 ft.lb} |
| 4 | Strut tower bar | - |