LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (On-Board Diagnostic - Pcm (VIN A) (2 Of 4)) >> DTC P0421-00: Catalytic Converter System (PYUL) >> Repeatability Verification Procedure

Repeatability Verification Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Start the engine and leave it idling for 1 min.
  2. Drive the vehicle normally for 15 min. After that, shift to 3rd gear and maintain the vehicle speed at approx. 40 km/h {25 mph}.
  3. Accelerate the vehicle to 60 km/h {37 mph} while in 3rd gear.
  4. Release the accelerator pedal and decelerate the vehicle to 40 km/h {25 mph}.
  5. Accelerate the vehicle to 60 km/h {37 mph} again while in 3rd gear.
  6. Drive the vehicle for 20 s at a speed of 50 km/h {31 mph} while in 3rd gear.
  7. Repeat Step  4 to  6 operations above 20 times.
    NOTE:
    • Match the engine coolant temperature in the recorded freeze frame data/snapshot data, the vehicle speed, and engine speed values to the best extent possible while driving the vehicle.
  8. Try to reproduce the malfunction by driving the vehicle for 5 min based on the values in the freeze frame data/snapshot data.
scientia non olet · About LEMON Manuals