LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical (VIN A) (3 Of 6)) >> Engine Disassembly/Assembly [PYUL] >> Remove Fuel Injectors >> Stopper ring installation note

Stopper ring installation note

WARNING: This page is about a different variant/trim than selected.
  1. Be careful of the stopper ring orientation as shown in the figure below, set a new stopper ring on the SST, and then press the fuel injector from above until it clicks.
    NOTE:
    • Always press the stopper ring perpendicular to the SST so that it is not inserted diagonally.
G16699698Courtesy of MAZDA MOTORS CORP.
SYMBOL AND CONTENT DESCRIPTION

Symbol Content
49 D013 104 (component part for 49 D013 1A0)
scientia non olet · About LEMON Manuals